|
 |
|
|
Material: PEEK Carbon Filled- Ketron® PEEK CA3030% carbon fibre reinforced grade combines even better mechanical properties than PEEK GF30 with an optimum wear resistance. The carbon fibres also provide a 3.5 times higher thermal conductivity than unreinforced PEEK - dissipating heat from the bearing surface faster.
|
Print Version
| Colour | - | - | Black | | Density | ISO 1183 | g/cm³ | 1.41 | | Water Absorption - saturation in air (23°c/50%RH) | - | % | 0.14 | | Water Absorption - saturation in water (23°c) | - | % | 0.30 | | Tensile strength*¹ | ISO 527 | N/mm² | 130 | | Tensile modulus of elasticity*¹ | ISO 527 | N/mm² | 7700 | | Elongation at break*¹ | ISO 527 | % | 5 | | Impact - Charpy*¹ | 179/1eU | kj/m² | 35 | | Impact – Charpy notched*¹ | 179/1eA | kj/m² | 4 | | Hardness | Rockwell Shore D | - | M102 | | Melt Point | - | °c | 340 | | Max service temp in air short periods | - | °c | 310 | | Max service temp continuously for 20000hrs | - | °c | 250 | | Linear thermal expansion coefficient | - | K-1x10-5 | 2.5 | | Thermal Conductivity | - | W/(K.m) | 0.92 | | Flammability*² (3mm thickness) | - | - | V-0 | | Volume resistivity*¹ | IEC93 | Ohm.cm | 105 | | Dielectric strength*¹ | IEC243 | Kv/mm | - | | Outside applications – UV resistance | - | - | A | | Acids – strong (Ph<3) | - | - | A | | Alkalis – strong (pH>11) | - | - | A | | Chlorinated Hydrocarbons | - | - | A | | Hot Water | - | - | A | | | | ‘A’ – Acceptable service, ‘B’ – Limited, ‘C’ – Unacceptable | | *¹ Measured on dry test specimens (where applicable) | | *² Tests completed by Quadrant EPP using UL test methods. |
|
Availability:Rod,500mm,1m & 3m long – 6-80mm diameter
Plate,500mm, 1m & 3m long x 525mm wide – 5-8mm thickness
Plate,500mm & 1m long x 305 & 625mm wide – 10-60mm thickness
Plate,3m long x 305 & 625mm wide – 10-25mm thickness
Tube, 1m & 3m long,50–200mm od x 30–160mm id.
Applications:Bearings, Valve Seats, Pump Components, Rollers, Gears, High Temp Insulation, Components in boiling water or steam.
|
|
The data shown are typical values and are not intended to represent specifications. Their aim is to guide the user toward a material choice. Not all material sizes shown within the availability programme of this data sheet are available as standard. Please contact ABG Rubber and Plastics Ltd for further details.
|
|
|
|