|
 |
|
|
Material: Nylon 66 - Ertalon® 66 SAMaterial with a higher mechanical strength, stiffness, heat and wear resistance than Ertalon® 6 SA. It also has better creep resistance but its impact strength and mechanical damping ability are reduced.
|
Print Version
| Colour | - | - | Natural(cream)/Black | | Density | ISO 1183 | g/cm³ | 1.14 | | Water Absorption - saturation in air (23°c/50%RH) | - | % | 2.4 | | Water Absorption - saturation in water (23°c) | - | % | 8.00 | | Tensile strength*¹ | ISO 527 | N/mm² | 90 | | Tensile modulus of elasticity*¹ | ISO 527 | N/mm² | 3450 | | Elongation at break*¹ | ISO 527 | % | >40 | | Impact - Charpy*¹ | 179/1eU | kj/m² | No break | | Impact – Izod notched | 180/2A | kj/m² | 4.5 | | Hardness | Rockwell Shore D | - | M88 | | Melt point | - | °c | 255 | | Max service temp in air short periods | - | °c | 180 | | Max service temp continuously for 20000hrs | - | °c | 80 | | Linear thermal expansion coefficient | - | K-1x10-5 | 8.0 | | Thermal Conductivity | - | W/(K.m) | 0.28 | | Flammability*² (6mm thickness) | - | - | V-2 | | Volume resistivity*¹ | IEC93 | Ohm.cm | >1014 | | Dielectric strength*¹ | IEC243 | Kv/mm | 27 | | Outside applications – UV resistance | - | - | A/B | | Acids – strong (Ph<3) | - | - | C | | Alkalis – strong (pH>11) | - | - | B/C | | Chlorinated Hydrocarbons | - | - | A/B | | Hot Water | - | - | B | | | | ‘A’ – Acceptable service, ‘B’ – Limited, ‘C’ – Unacceptable | | *¹ Measured on dry test specimens (where applicable) | | *² Tests completed by Quadrant EPP using UL test methods. |
|
Availability:Rod,1m & 3m long – 5-250mm diameter
Sheet,1m & 2m long x 1m wide - 2-6mm thickness
Plate,1m & 3m long x 610 wide – 8-100mm thickness
Tube,1m & 3m long x 20–100mm od x 10–80mm id.
Coiled Strip,0.25–3.18mm thick x 25.4-101.6mm wide (Length dependent on thickness)
Applications:Racks, Pinions, Gears, Bearings, Rollers, Wheels, Cams, Nuts, Valve seats, Pulleys, Gaskets, Electrical Insulato
|
|
The data shown are typical values and are not intended to represent specifications. Their aim is to guide the user toward a material choice. Not all material sizes shown within the availability programme of this data sheet are available as standard. Please contact ABG Rubber and Plastics Ltd for further details.
|
|
|
|